Proper surface preparation is essential to achieve maximum product performance! Surface must be porous prior to application of Preserva Crete™. To check for porosity in any given area, a single drop of water should be readily absorbed. Any previous coatings or efflorescence (salt bleed from mortar or grout) must be removed with a concrete cleaner or sandblasting. The surface must be free of dirt, oil, grease and other foreign objects prior to application of Preserva Crete™. Rinse well after using cleaning chemicals and allow surface to dry thoroughly before applying Preserva Crete™.

Tip: Consider using our Preserva Crete™ Cleaner & Etcher before treating, to make sure your concrete is properly prepared.  Preserva Crete™ Cleaner & Etcher is the safer, water-based alternative to other products using strong acids and corrosive solutions. It’s simple and easy to use, allowing you to thoroughly clean just about any textured or bare concrete or masonry surface in an environmentally-responsible fashion. Click here to learn more.

COVERAGE

The porosity of your concrete or masonry surface can vary over a broad range. Coverage will vary from approximately 100 to 200 square feet per gallon, depending on the surface and its condition.

Do not thin, ready to use as is! Shake or stir before using. Apply a small amount of Preserva Crete™ in an inconspicuous area and allow to dry  in order to insure your satisfaction with the final appearance. The product should be applied evenly over the entire surface with a pump sprayer, brush, or roller.

Do not allow Preserva Crete™ to puddle on surface. Brush excess into areas that absorb material faster. Only one coat of Preserva Crete™ is necessary for best results. Do not over-apply. Apply Preserva Crete™ in the cool of the day. Do not apply product to a hot surface, or in the heat of the day. Penetration and final performance will be effected.

Dry Time: Treated masonry will be dry to the touch in 1 hour, 24 hours for foot traffic, and 48 hours for vehicles or furniture placement. Rinse plants, lawns, windows, or any other items that may have come in contact with Preserva Crete™ using clean, clear water.

Clean up should be done with warm water and soap. Excess material should be stored or disposed of in accordance with local regulations for disposal of silicate based liquids. Consider donating excess material to a local non-profit organization.